Piper PA-18-150 Complete Engine Baffle Set

Piper PA-18-150 Complete Engine Baffle Set

These baffles are FAA/PMA approved, have the silicone seals attached, and arrive ready to install

About our baffles in general:

• Baffles are made of 6061-T6 aluminum with many improvements over the original baffling.
• Improvements include: stainless steel brackets where needed, hard rivet construction, half inch backing plates on seals, and an improved fit to increase engine cooling.
• All Airforms engine baffles are designed to replace the factory installations and are individually interchangeable.
• The baffle seals are fiberglass reinforced, high temperature silicone: black is standard. Orange or blue are available for an extra charge.
• We also sell seal kits if your metal baffle pieces are in good shape .

Note:

• If aftermarket components of differing dimensions have been installed, it is the installer's responsibility to adjust the baffles to fit. Components include: starters, alternators, exhaust, etc.
• Mounting hardware is not included (nuts, bolts, screws, washers, retaining springs, and Tinnerman clips).
• Engine: Lycoming 0-320-A2A

Advantages of Cowl Saver:

• Reduces transfer of vibration to the engine cowl and airframe
• Eliminates cowl erosion
• Extends baffle seal life
• Reduces expensive cowl and cowl fastener repairs
• Reduces fatigue and cracking in baffles, cowl skins and firewall